The Universal Vision Bright Tough Mount 4pc. Lighting Kit

On Sale Now through 04/30/2016- $89.95

Vision Bright Tough Mount Universal 4pc. lighting Kit

Part# 145VBTMU-4
Set of 4 includes
4- Vision Bright Tough Mounts
4- 30 LED 12VDC/ 12” IP67 LED Light Strips W/ 20ga, wiring attached to both ends of strip for ease of installation.
Choice of Colors- Red, White, Blue, Green, Amber, Pink/Purple and UV
16’of 22ga. 2wire
1- Rocker Switch w/ elect. connectors
8- Stainless Steel Pan head #10 fasteners
4- Stainless Steel Flat #10 fasteners
Suggested Retail: $129.95 US

Regular price: $99.95

Sale Price: $89.95

LMPWDesigns.com


VBTMounts- Helpful Tips 2

Checking the current (Load) on your 12VDC LED light systems

Testing amperage using a multi-meter

.6 to .7 amps

When using an electrical multi meter to measure amperage make sure the leads are in there proper banana Jack outputs. (Red lead in the AMP jack and Black lead in the COM jack) selector switch set to Amps/DC . Think of the meter leads being connected “one with the circuit” (in series)

In a series circuit, the rule states that the load will stay the same throughout the entire circuit, so when measuring with a multi meter you can check the amperage at any point along the circuit as long as you check it in series with the circuit. The easiest way to test your amp load is to remove the fuse and place your meter leads to the fuse contacts.

Our test will be measuring DC (Direct Current) and using a 12VDC supply to check the amperage draw or load on a LED light system. Remember when doing this test, have the power off until you’re ready to record your measurement. (Red (+) lead to the positive or supply side of the open contacts and place the Black (-) lead to the ground side of the open contact).

Now, you’re ready to power up or turn on your lighting system (make sure your circuit or your LED lights are lit up) record your reading on the meter.

After verifying the load on the circuit this will help determine your fuse rating needed. A maximum of a 5 amp fuse is recommended. For this circuit a 3 amp would be plenty to handle the load and protect the system.

The measurement readings taken for this test is based on a 10pc Vision Bright Tough Mount w/12VDC LED 12″ light strips.

If you found this tip helpful you may like: Helpful Tip 1